Today's homes are full of expensive electronics — HVAC control boards, smart appliances, computers, TVs, EV chargers, smart panels. A single power surge from a lightning strike, a downed line, or a utility switch can fry them all in a fraction of a second. A whole-house surge protector mounted at your electrical panel stops surges before they reach anything inside your home.
Total Plumbing Pros installs Type 2 whole-house surge protectors from Eaton, Square D, Siemens, and Leviton across Mooresville, Charlotte, Lake Norman, and surrounding NC and SC communities. Licensed install, permit handled where required, and a clean panel mount that's out of the way.
Signs You Need Whole-House Surge Protection
ANY MODERN HOME, REALLY
If your home has central HVAC, smart appliances, computers, or an EV charger, you have enough electronics to justify whole-house protection. Most homes don't have it yet.
LIVE IN A LIGHTNING-PRONE AREA
The Carolinas see frequent thunderstorms. A direct or near-miss lightning strike sends voltage spikes through utility lines into homes.
RECENT APPLIANCE FAILURES AFTER STORMS
If your HVAC, microwave, garage door, or other electronics have failed without obvious cause, surge damage is a likely culprit.
INSTALLING NEW HIGH-VALUE ELECTRONICS
EV chargers, solar systems, home batteries, smart panels, and high-end home theaters are all worth protecting at the panel — for pennies on the dollar of the gear itself.
What's Included
- Type 2 whole-house surge protector mounted at the main panel
- Choice of brand (Eaton, Square D, Siemens, Leviton) and joule rating
- Installation of a dedicated breaker for the surge device
- Status indicator visible for at-a-glance verification it's still protecting
- Permit and inspection where required by jurisdiction
- Workmanship warranty
Typical Pricing
$300 – $700
Most whole-house surge protectors in our area install for $300 to $700 fully installed — the device itself plus labor and any small panel work. Top-tier units with higher joule ratings and connected-device warranties sit at the top.
Our Process
- 1
Free quote
We confirm your panel type, recommend the right device, and quote it flat-rate.
- 2
Installation
Power is cut at the main, the surge protector is mounted on a dedicated breaker, and connections are torqued to spec.
- 3
Test + indicator check
Power is restored and the device's status indicator (typically a green LED) is verified working.
- 4
Walkthrough
We show you the device, explain what it does, and note that the LED will alert you if it ever needs replacement (after absorbing a major hit).
Brands We Service
Total Plumbing Pros installs and services every major electrical brand:
Industry Standards & Resources
Our whole-house surge protection work follows the standards published by these national authorities:
Whole-house surge protection is the highest insurance-vs-cost ratio of any single electrical upgrade. Total Plumbing Pros installs to NEC code, with permits where required, in 30–60 minutes per panel — and backs every install with our workmanship guarantee.
Frequently Asked Questions
Related Electrical Services
Whole-House Surge Protection Service Areas
We provide whole-house surge protection across the Lake Norman and Charlotte metro area:
Other Services We Offer in Mooresville
A trusted full-service provider for your whole home — fewer contractors, faster results.